Before Operation - Vcr Part; Tuning In A Video Channel On Your Tv; Using Your Dvd+Vcr For The Very First Time - Philips DVP 3055V Owner's Manual

Before Operation - VCR part

Tuning in a video channel on your
TV
Video channel (RF output channel) is the channel on
which your TV receives picture and sound signals from the
DVD+VCR through the RF cable.
If you have used a lead you will not have to tune
SCART
your TV, simply select the AV channel.The AV channel is
already pre-tuned for optimum video playback on your TV.
Perform the following steps only if interference appears in
the TV picture after you have moved to a different area or
a new station has started broadcasting in your area, or if
you change the connection from RF connection to AV
connection, or vise versa.
1
Turn on DVD+VCR and TV.
2 Set the vacant position 36 on your TV.
3 Press 1 1 on the remote control to enter the standby
mode (the clock indicator will be dimmed).
4
Press and hold CHANNEL 3 or 4 on the DVD+
VCR for more than 4 secs.
RF 36 will appear in the DVD+VCR display.
The following picture will be displayed on the TV screen.
RF CHANNEL
If the picture is snowy, move to step 5. If the picture is
clean, press 1 1 on the DVD+VCR to finish.
5
Press CHANNEL 3 or 4 on the DVD+VCR to set
the video channel to a vacant position between 22
and 68 which is not occupied by any local station in
your area.
Note
The RF channel will not change until step 6 has been
executed.
6 Press 1 1 to store the new RF video channel into the
DVD+VCR memory.
Now tune your TV set to the new DVD+VCR RF
channel.
Note
If the TV picture was clear in step 4, do not retune your
TV.
12

Using your DVD+VCR for the very first time

1
2
36
3
For the following steps we assume that you have just
connected your DVD+VCR for the very first time.
To make tuning TV stations an easy task your DVD+VCR
incorporates the Automatic Channel Memory
System (ACMS).This system will automatically tune,
store TV channels in your DVD+VCR.
Make sure that you have correctly installed your
DVD+VCR.
Press 1 1 to turn on your DVD+VCR.
If the initial Menu Screen doesn't appear on screen, make
sure that you have tuned your TV to a video channel. Or if
this is correct it may mean that your DVD+VCR is already
tuned.
ACMS
Pr-12
ACMS
Press OK to start the automatic tuning process.
01 C02 00
02 C03 00
03 C04 00
S
Pr-12
ACMS
Press SYSTEM MENU to remove the menus from
the TV screen.
OK i
E
i