Philips DVDR80 Operating Instructions Manual page 107

User preferences
Depending on which audio outputs are used, you can select the settings in this menu.
If you only use the analogue audio output ( OUT AUDIO L/R ), select the settings '
' ' menu.
You can select one of the following settings for devices that are connected to the COAX
OUT or OPTICAL AUDIO OUT sockets:
: Dolby Digital and DTS signals are fed unaltered to the digital output. MPEG-2 multi-channel
signals are converted to PCM (Pulse Code Modulation).
For receivers/amplifiers
: Dolby Digital and MPEG-2 multi-channel signals are converted to PCM (Pulse Code
Modulation).
For receivers/amplifiers
: Digital output switched off.
For devices
For devices connected to the analogue audio output ( OUT AUDIO L/R ), you can select from
the following settings.
: For devices without DolbySurround or TruSurround. Use this setting if the DVD
recorder is only connected to a stereo TV set.
: Dolby Digital and MPEG-2 multi-channel are mixed down to a DOLBY
surround-compatible two-channel output signal.
For devices
Night mode optimises the sound for playback at low volume. You are therefore less likely to
disturb your neighbours. This only works for Dolby Digital audio on DVD video discs.
You can choose the following settings in this menu:
Playback audio language
Selection of audio recording for bilingual programmes
.
.
' in the
.
.