NEC POWERMATE 2000 Service And Reference Manual page 42

Menu Item
I/O Device Configuration
Serial Port A
Base I/O
Address
Interrupt
Parallel Port
Mode
Base I/O
Address
Interrupt
Floppy Disk Controller
Base I/O
Address
Large Disk Access Mode
Local Bus IDE Adapter
2-14 System Configuration
Advanced Menu
Settings (default is bold)
Press Enter to access the following submenus.
Disabled, Enabled, Auto
Setting at Enabled allows the user to configure the port.
Setting at Auto enables the BIOS or operating system to
configure the port.
3F8, 2F8, 3E8, 2E8
Selects the base I/O address for serial port A.
IRQ3, IRQ4
Selects the IRQ for serial port A.
Disabled, Enabled, Auto
Setting at Enabled allows the user to configure the port.
Setting at Auto enables the BIOS or operating system to
configure the port.
Output Only, Bi-directional, EPP, ECP
Selects parallel port mode.
378, 278, 3BC
Selects the base I/O address for the LPT port.
IRQ5, IRQ7
Selects the IRQ for the LPT port.
Disabled, Enabled, Auto
Setting at Enabled allows the user to configure the controller.
Setting at Auto enables the BIOS or operating system to
configure the controller.
Primary, Secondary
Sets the base I/O address for the controller.
Other, DOS
Select DOS if using DOS operating system.
Select Other if using another operating system such as UNIX
or Novell NetWare.
Disabled, Primary, Secondary, Both
Enables the integrated local bus IDE adapter.