Setting Up The Operating System And Drivers - Sun Microsystems Ultra 40 M2 Installation Manual

If the workstation power is not shut off through the operating system command
■
or this command is not available, press and release the power button (see
for the location).
FIGURE 1-3
This action initiates an orderly shutdown of the operating system and powers off
the workstation.
Caution – To avoid data loss, use the preceding two options whenever possible.
If the workstation is not shut off after using the first two preferred methods, press
■
and hold the Power button for approximately four seconds.
This action immediately shuts down the power to the workstation without
operating system intervention. This method could result in data loss.
If the preceding options fail to power off the workstation, see the Sun Ultra 40
Workstation Service Manual (820-0123) for additional troubleshooting information.
Note – After powering off the workstation, wait at least four seconds before
powering on the workstation again.
Setting Up the Operating System and
Drivers
This section describes how to set up the operating system. You can set up the
preinstalled Solaris 10 operating system or install an additional operating system
and drivers.
For information on setting up the operating system and software:
If you plan to use the installed operating system, see
■
Solaris 10 Operating System" on page 12
If you plan to install an additional operating system, see
■
Operating System and Drivers" on page
See "Exploring Preinstalled Developer Software" on page 15
■
information on preinstalled Sun Ultra 40 M2 Workstation software.
"Setting Up the Preinstalled
.
"Installing an Additional
13.
for additional
Chapter 1 System Setup 11