Cabling The Workstation - Sun Microsystems Ultra 40 M2 Installation Manual

Cable Connections
FIGURE 1-6

Cabling the Workstation

1. Connect the workstation power cord to a grounded electrical outlet.
2. Connect the keyboard and mouse to the USB connectors on the back panel.
3. Connect the monitor cable to a graphics card video connector installed in a PCI-
Express graphics slot.
Note – You might need to use the DVI adapter included with the workstation to
connect the graphics card to the monitor. If your workstation has an NVS285
graphics card installed, a DMS-59 cable will be packaged with the workstation. If
you are using a different graphics card, you will need to use the adapters for that
specific card.
4. Connect the Ethernet cable to one of the Ethernet connectors on the Sun Ultra 40
M2 Workstation, and connect the other end of the cable to an Ethernet RJ-45 jack.
5. Connect any additional external devices to the workstation's other connectors.
Chapter 1 System Setup 9