Address Setting; Setting The Address; Example Address Setting - Mitsubishi FX2N-32DP-IF User Manual

FX2N-32DP-IF Profibus-DP Interface Unit
6.

Address Setting

6.1

Setting the Address

The slave address of 32DP-IF for Profibus network is set by the ON/OFF configuration of DIP
switches. Slave address setting range is 0 ~ 126. When 32DP-IF's power supply is turned ON,
the slave address is the sum total of these DIP switch values.
Figure 6.1: DIP Switches
This DIP switch is not
used for the address
setting. Please leave in
the OFF position.
Note:
If the address of 32DP-IF is changed, the 32DP-IF must be turned OFF and ON again in
order to activate the new address.
6.2

Example Address Setting

If slave address of 32DP-IF is set to "22", the DIP switches are as shown below.
Figure 6.2: Address Setting
These DIP switches
are OFF.
ON
OFF
Address Setting 6
This is the DIP switch value.
ON
OFF
This DIP switch is ON.
6-1