Cranking The Engine - Yanmar 6LPA-STP2 Operation Manual

CRANKING THE ENGINE

When performing engine break-in or if the
engine has not been used for a long period
of time, engine oil will not be distributed to
all of the operating parts. Using the engine
in this condition will lead to seizure.
After a long period of non-use, distribute
engine oil to each part by cranking the
engine. Perform the following procedure
before beginning operation:
1. Open seacock (if equipped).
2. Open fuel cock.
3. Put remote control shift lever in
NEUTRAL.
4. Turn battery switch to ON (if equipped).
(5)
Figure 10
5. Turn key to ON (Figure 10, (3)). It is
normal for the alarm to sound and the
warning indicators to light during
cranking.
Note: If the engine has not been
operated for a long period of time,
check that the key can be moved
from START to ON positions
smoothly.
6. While pushing the STOP button
(Figure 10, (1)), turn the key to the
START position (Figure 10, (2)).
NOTICE: NEVER hold the key in the
START position for longer than 15
seconds or the starter motor will
overheat.
6LPA Series Operation Manual
(4)
(1)
(3)
(2)
0004890
© 2007 Yanmar Marine International
BEFORE YOU OPERATE
7. When the key is in the START position,
the engine will begin cranking.
Continue cranking for about 5 seconds
and listen for abnormal noise during
that time.
Note: If the STOP button is
released during the cranking
procedure, the engine will start. Do
not start the engine in this mode.
8. Move key to OFF position
(Figure 10, (4)). The engine will stop
cranking.
35