Table of Contents
Advertisement
Product
Models ZISS36D, ZISS36N
A – 36" outside trim width
Dimensions
B – 35" case width
All Models
C – 10-3/4" to 12-1/4"
D – 72-1/4"
E – 84" Shipping height
F – 24-3/4" (excluding handles)
G – 26-3/4" (including handles)
H – 4"
Refrigerators are much heavier at the top than
at the bottom – be extra careful when moving.
Les réfrigérateurs sont beaucoup plus lourds en
haut qu'en bas. Il faut être prudent lors des
déplacements.
These refrigerators are equipped with special
Clearances
hinges that allows the door to swing out and
away from the cabinet. No clearances are
required on the sides.
When the refrigerator is installed in a corner:
• A 4" min. clearance between the case trim
The water line can be routed through
Electrical and
the floor or back wall.
Water
• Water line should be:
– Approximately 3-1/2" from the floor on the
Connection
Locations
– At least 5" from either side of the opening.
A 115 volt, 60 Hz. 15 or 20 amp power supply
is required. An individual properly grounded
branch circuit or circuit breaker is recom-
mended, as noted on the rating plate. The
rating plate is located on the top on the
evaporator box and is visible when grille
panel is removed.
• Locate the electrical outlet within 5" x 7"
shaded area shown. From the right side:
12-3/8" for 36" models, 18-3/8" for 42" models,
20-3/8" for 48" models
• Between 74" and 81" from the floor.
These refrigerators are supplied with a grille
Accessories
panel cover sized to fit a typical 84" installation
height. If the installation height varies, order:
ZGSSW42 for 42" wide models
ZGSSW48 for 48" wide models
Adjustable from 83" to 84-1/2"
CAUTION
PRUDENCE
back wall, or 3-1/2" from the back wall on the
floor.
Installation Preparation
Models ZISS42D, ZISS42N
A – 42" outside trim width
B – 41" case width
and the adjacent wall on both sides of the
refrigerator will assure a 90° door opening
and access to all drawers.
• A 10" clearance on both sides is required for
removal of pans.
3 1/2"
Important: To insure a flush fit and access to the power
cord, locate the electrical outlet as shown.
These kits include 3 grille panels for 83",
83-1/2" and 84-1/2" installation heights.
Stainless Steel Built-In Refrigerators
Models ZISS48D, ZISS48N
A – 48" outside trim width
B – 47" case width
A
B
C
E
D
Electrical Outlet Location
7"
5"
5"
Water Location
G
F
H
36" Models 12 3/8"
42" Models 18 3/8"
48" Models 20 3/8"
74"
5
Advertisement
Table of Contents
