Connections; Step 1: Placing Speakers - Philips MCD510/21 User Manual

S-VIDEO
IN
AUDIO
IN
VIDEO IN
speaker
(right)
IMPORTANT!
– The type plate is located at the rear of
the system.
– Before connecting the AC power cord
to the wall outlet, ensure that all other
connections have been made.
– Never make or change any
connections with the power switched on.
– The voltage selector located at the
bottom of this system is preset at
220V-240V from the factory. For
countries that operate at 110V-127V,
please adjust to 110V-127V before you
switch on the system.
To avoid overheating of the system, a
safety circuit has been built in. Therefore,
your system may switch to Standby
mode automatically under extreme
conditions. If this happens, let the system
cool down before reusing it (not available
for all versions).
AUDIO
IN
TV IN
DIGITAL DIGITAL
OUT OUT
LINE OUT LINE OUT
FM/MW ANTENNA
R R L L
FM 75Ω
R L
AM ANTENNA FM ANTENNA
AUX/
CDR IN
SUB
WOOFER OUT
+
R
L
+
SPEAKERS 6Ω
S-VIDEO
FM wire
Cr
IN
antenna
Cb
VIDEO IN
Y
3 3

Step 1: Placing speakers

Front
speaker
( left )
Place the front left and right speakers at equal
distances from the TV set and at an angle of
approximately 45 degrees from the listening
position.
Notes:
-To avoid magnetic interference, do not position the
front speakers too close to your TV set.
-Allow adequate ventilation around the DVD
System.

Connections

MW loop
antenna
speaker
(left)
5
AC power cord
Front
speaker
( right )
VIEWING AREA
11