Preparations; Step 1: Inserting Batteries Into The Remote Control; Using The Remote Control To Operate The System; Step 2: Setting The Clock - Philips MCD510/21 User Manual

IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
Step 1: Inserting batteries into
the remote control
1
Open the battery compartment.
2
Place two batteries (Type R06 or AA) in the
compartment with the correct polarity as
indicated by "+" and "–" symbols.
3
Close the cover.
Using the remote control to operate the
system
1
Point the remote control directly at the remote
sensor (iR) on the front panel.
2
Select the source you wish to
control by pressing one of the
source select buttons on the
remote control (for example
TAPE, TUNER).
3
Then select the desired function
(for example 2;, í, ë).
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.

Step 2: Setting the clock

1
In standby mode, press and hold CLOCK SET
on the system.
➜ "SET CLOCK" appears. Then, the clock digits
for the hours flash.
2
Press TUNING S T on the system to
set the hours.
3
Press CLOCK SET again.
➜
The clock digits for the minutes flash.
4
Press TUNING S T on the system to
set the minutes.
5
Press CLOCK SET to confirm your setting.
The system will store the setting automatically.
➜
The time setting becomes effective.
Note:
– The clock will be cancelled when the power cord
is disconnected or if a power failure occurs.
– During setting, if no button is pressed within 30
seconds, the system will exit clock setting mode
automatically.

Preparations

21