Bosch Solution 3000 Quick Reference Manual page 18

18 en | Operating Commands
Fault Indicators
Zone
Indicator
1
2
3
4
5
6
7
8
Table 3.3: Fault Indicators
Fault Descriptions
1 System Fault
A system fault only displays when any of the following faults occur. After entering Fault
Analysis Mode, press the [1] key to determine which of the following faults occurred.
Low Battery Fault – A low battery fault registers when the system detects a low capacity
back-up battery. The system automatically performs a battery test every four hours and every
time you arm the system.
Date and Time – The date and time fault registers every time the system is powered down.
RF Receiver Fail – This fault registers when the RF wireless receiver unit detects RF jamming,
the RF wireless receiver is disconnected from the control panel or failed, or the RF receiver's
cover tamper switch is activated.
Output 1 to 3 Fail – This fault registers when the system detects output 1 – 3 as warning
device (Horn Speaker, Siren Running, Strobe) is disconnected or short. This fault clears once
all outputs are reconnected. Your installer must program the system for this feature to
operate.
2015.06 | 03 | F.01U.298.027
Fault Description Press
Button
System Fault 1
RF Low Battery 2
(Solution 2000
N.A.)
Zone Tamper Alarm 3
Sensor Watch Fault 4
RF Sensor Missing 5
(Solution 2000
N.A.)
Communication Fail 6
Output and 7
Codepad Fail
Keyfob Low Battery 8
Quick Reference Guide
Zone Fault Condition
Indicator
1 Battery Fail
2 Date and Time
3 RF Receiver Fail
4 Output 1 to 3 Fail
5 Telephone Line Fail
7 Power Supply Fail
8 Onboard Tamper
9 to 16 RF Repeaters 1 to 8 Fail (Solution
2000 N.A.)
1 to 16 Zones 1 to 16 RF Low Battery
1 to 16 Zones 1 to 16 Tamper Alarm
1 to 16 Zones 1 to 16 Sensor Watch Fail
1 to 16 Zones 1 to 16 RF Sensor Watch Fail
1 Receiver 1 Fail
2 Receiver 2 Fail
3 IP Module 1 Fail
4 IP Module 2 Fail
1 to 2 Output Expanders 1 to 2 Fail
3 to 6 Codepads 1 to 4 Fail
1 to 16 Keyfobs 1 to 16 Low Battery
Control Panel
Bosch Security Systems, Inc.