Faults And Tamper Conditions; System Fault Or Tamper Analysis Mode Via Text Keypad; System Fault Or Tamper Analysis Mode Via Led/Lcd Keypad - Bosch amax 2100 Operation Manual

42 en | Faults and tamper conditions
14

Faults and tamper conditions

Whenever a system fault or tamper condition occurs, the FAULT
indicator flashes and the keypad beeps.
Notice!
This operation is only possible in disarmed status.
14.1 System fault or tamper analysis mode via
text keypad
To display the fault or tamper analysis for describing a system
fault or tamper condition, perform the following steps:
1.
2.
3.
14.2 System fault or tamper analysis mode via
LED/LCD keypad
How to display faults and tampers via a LED/LCD keypad
1.
2.
3.
4.
5.
2017.04 | 07 | F.01U.295.569
Enter your code + [2] [1] and press [#].
The system beeps twice and the fault or tamper conditions
are displayed.
Use [▲] and [▼] to display all fault or tamper conditions.
Press [#] to exit.
Enter your code + [2] [1] and press [#].
The system beeps twice. The FAULT indicator is
extinguished and the STAY and AWAY indicators flash. One
of the number indicators is lit. Example: 2.
Enter the number that is lit in the system. Example: 2.
One of the number indicators is lit. Example: 1.
Repeat step 2 until there is no number lit anymore.
Refer to the table Types of fault or tamper conditions for a
description of the fault or temper. The consecutively lit
number indicators correspond to fault or tamper types.
Example: 2 – 1, which indicates a panel AC failure.
If necessary press [0] to return to step 2.
Bosch Sicherheitssysteme GmbH
AMAX panel