Troubleshooting - Bissell SPOTCLEAN CORDLESS 1923 SERIES User Manual

Troubleshooting

Problem Possible causes
Battery isn't fully charged
Spot Cleaner
won't turn on
Wrong charger being used
Clean water/solution tank empty
Spray nozzle clogged
Clean water/solution tank insert
Reduced
clogged
spray or
Pump needs priming
no spray
Batteries weak/undercharged
Poor upholstery/carpet
tool position
Dirty water tank is full
Spot Cleaner
won't pick
Upholstery/carpet tool brush worn
up cleaning
Excess solution in flex hose
solution
Incorrect cleaning formula
Charger plug/cord not connected
Spot Cleaner
will not
charge
Duckbill valve is dirty
Dirty Water
Tank Leaking
Please do
not return
this product
to the store.
Other maintenance or service should be performed by an authorized
service representative.
Thank you for selecting a BISSELL product.
Remedies
Charge battery. Follow charging
battery instructions on page 5.
Be sure to use only the charger
supplied with your product.
Check/fill tank
Clean spray nozzle using an unfolded
paper clip
Clean insert at bottom of clean water/
solution tank
Gently lift clean water/solution tank
while depressing the spray trigger
OR gently squeeze clean tank while
depressing spray trigger
Recharge according to instructions
on page 5.
Reposition upholstery/carpet tool
on surface, follow recommended
cleaning procedures on pages 6-7.
Empty dirty water tank
Replace with new brush
Lift tool and point upwards to allow water
in hose to flow into the dirty water tank
Use BISSELL 2X Portable Machine
formulas (and BISSELL Oxygen Boost
if desired) only
Make sure charger plug is completely
plugged into wall outlet and charging
cord is completely plugged into port on
back of unit.
Clean the duckbill valve that is
located at the bottom of the dirty
water tank. Once cleaned, make
sure it is placed securely back in
place.
www.BISSELL.com
9