Service Position To Check The Camera Section - Sony DCR-PC101E Service Manual

DCR-PC101/PC101E

[SERVICE POSITION TO CHECK THE CAMERA SECTION]

Connection to Check the Camera Section
To check the camera section, set the camera to the "Forced camera power ON" mode. (Or, connect the control switch block (PS-2850) to the
CN-402 of ME-020 board and set the power switch to the "CAMERA" position.)
Operate the camera functions of the zoom and focus using the adjustment remote commander (with the HOLD switch set in the OFF
position).
Setting the "Forced Camera Power ON" mode
1) Select page: O, address: 01, and set data: 01.
2) Select page: D, address: 10, set data: 01 and press the PAUSE
button of the adjustment remote commander.
CPC-6 terminal board jig
(J-6082-371-A)
Control switch block
(FK-2850)
Seal rubber
Lens block
Optical filter
block
CPC-6 flexible jig
(J-6082-370-B)
Two screws
×
(M1.7 5)
Mechanism deck
CF-089 board
Exiting the "Forced Camera Power ON" mode
1) Select page: O, address: 01, and set data: 01.
2) Select page: D, address: 10, data: 00, and press the PAUSE
button of the adjustment remote commander.
3) Select page : 0, address: 01, and set data: 00.
Adjustment remote
commander (RM-95)
ME-020 board
VC-284 board
AC power
AC IN
adaptor
2-14
When exiting the
Forced Camera Power ON mode,
connect the control switch block (PS-2850)
to the CN402 of ME-020 board.
Control switch block
(PS-2850) (10P)
BJ-003 board
DC-IN connector