Configuring An Sdp; Sdp Configuration Tasks - Alcatel-Lucent 7210 SAS M Service Manual

Configuring an SDP

Use the following CLI syntax to create an SDP and select an encapsulation type. Only MPLS
encapsulation is supported.
NOTE: When you specify the far-end ip address, you are creating the tunnel. In essence, you are
creating the path from Point A to Point B. When you configure a distributed service, you must
identify an SDP ID. Use the show service sdp command to display the qualifying SDPs.
When specifying MPLS SDP parameters, you must specify an LSP. If an LSP name is specified,
then RSVP is used for dynamic signaling within the LSP.
LSPs are configured in the config>router>mpls context. See the 7210 SAS M MPLS Guide for
configuration and command information.
Use the following CLI syntax to create an MPLS SDP:
CLI Syntax: config>service>sdp
7210 SAS M Services Guide
adv-mtu-override
description description-string
far-end ip-address
keep-alive
hello-time seconds
hold-down-time seconds
max-drop-count count
message-length octets
timeout timeout
no shutdown
lsp lsp-name [lsp-name](only for MPLS SDPs)
path-mtu octets
signaling {off | tldp}
no shutdown
[mpls] create
sdp-id
Services
Page 71