Alcatel-Lucent 7210 SAS M Service Manual page 413

all-zeros — Specifies to use all zeros in the test pattern.
Parameters
all-ones — Specifies to use all ones in the test pattern.
crc-enable — Generates a CRC checksum.
low-priority-defect
Syntax low-priority-defect {allDef|macRemErrXcon|remErrXcon|errXcon|xcon|noXcon}
Context config>service>vpls>mesh-sdp>eth-cfm>mep
config>service>epipe>sap>eth-cfm>mep>eth-test-enable
This command specifies the lowest priority defect that is allowed to generate a fault alarm.
Description
macRemErrXcon
Default
mac-address
Syntax mac-address mac-address
no mac-address
Context config>service>vpls>mesh-sdp>eth-cfm>mep
This command specifies the MAC address of the MEP.
Description
The no form of this command reverts the MAC address of the MEP back to that of the port (if the
MEP is on a SAP) or the bridge (if the MEP is on a spoke).
mac-address — Specifies the MAC address of the MEP.
Parameters
7210 SAS M Services Guide
all-zeros
Default
allDef
Values
macRemErrXcon
remErrXcon Only DefRemoteCCM, DefErrorCCM, and DefXconCCM
errXcon
xcon
noXcon
6-byte mac-address in the form of xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx of the
Values
MEP. Must be unicast. Using the all zeros address is equivalent to the no form of
this command.
DefRDICCM, DefMACstatus, DefRemoteCCM, DefErrorCCM,
and DefXconCCM
Only DefMACstatus, DefRemoteCCM, DefErrorCCM, and
DefXconCCM
Only DefErrorCCM and DefXconCCM
Only DefXconCCM; or
No defects DefXcon or lower are to be reported
Virtual Private LAN Services
Page 413