Omron C200H Operation Manual page 22

Before Operation
Wiring Methods
12
Use the connectors provided with the Unit to wire input lines. (Connec-
tor: MR-34FG; Cover: MR-34L; both manufactured by Honda Communications;
Connector/Cover Set: MR-34LFG).
Be sure to tighten the lock screws whenever attaching the connector to the Unit.
Use wires with a diameter of 0.3 mm
Wiring Method
Wiring
Connector
Do not forget to connect one of cable shield terminals to the FG terminal.
Do not remove the protective seal from the Unit until wiring has been completed.
This seal will prevent wire clippings and other debris from entering the Unit and
possibly preventing proper operation. Always remove this seal before operation.
If the seal is left in place, the Unit may overheat, possibly causing improper op-
eration or damage to the Unit.
Before Wiring
2
maximum.
Heat-shrinking
tube
After Wiring
Section 2-1
Connector Assembly
Round-head screw
Cover
Connector
lock screw
Connector
(jack)
Remove
the label.