Table of Contents
Advertisement
SENSORS
Add-On Sensors
Adding Sensors to Your Display
1.
Hold the
EXTRA SENSOR ( )
Sensor Reception Indicator ( ) starts to animate.
Inside of Water Leak Sensor*
2.
Install batteries into your sensor. If the sensor has
a
TX
button, press it to force a transmission signal.
This button is usually located in or near the sensor's
battery compartment. The LED light on the sensor
will flash once.
3.
Your sensor should connect within the next three
minutes. The Sensor Reception Indicator ( ) will
appear solid when a sensor is connected.
* Water Leak Sensor shown as example, sensor not included
24
button until the
Top of Water Leak Sensor*
Viewing Add-On Sensor Data
Tap the
EXTRA SENSOR ( )
between pressure and add-on sensor readings,
or select the Auto-Scroll option to cycle through
all available pressure and sensor data.
Programming the Auto-Scroll Option
Tap the
EXTRA SENSOR ( )
AUTOSCROLL appears on the display.
The Auto-Scroll Icon ( ) located in the top left
corner will appear when active.
To deactivate the Auto-Scroll option, tap the
EXTRA SENSOR ( )
Icon ( ) disappears. The display will stay on
your current selection.
button to switch
button until
button until the Auto-Scroll
Advertisement
Table of Contents
