Displaying Guidelines; Adjusting The Guidelines - Clarion NX505E Owner's Manual

Displaying guidelines

1
Touch the screen while the rear
camera image is displayed.
2
Guideline
If five seconds elapses without you
touching the screen, Guideline will be
hidden.
3
Check
The guidelines are displayed.
A
C B C
A: Position about 2 m from the rear
end of the vehicle
B: Position about 50 cm from the rear
end of the vehicle
C: Approximately vehicle width + 20
cm

Adjusting the guidelines

When adjusting guidelines, marks must
be drawn on the ground. Prepare tools for
drawing lines on the ground, such as duct
tape. Also, be sure to do the adjustments to
match the car you drive.
WARNING
• Before adjusting the guidelines, stop
at a safe location.
• Before getting out of the vehicle and
marking the ground, be sure to turn
the engine key to the "OFF" position.
• Remember that guidelines are solely
for reference. During actual driving,
be sure to check the safety of the
area around you yourself.
1
Mark straight marks on the
ground at vehicle width + about
20 cm positions.
Approx. 20 cm
Approx. 20 cm
MEMO:
• Mark on both sides of the vehicle
using packaging or similar tape.
• Make the marks slightly longer than
the length of the vehicle.
2
Drive the vehicle forward by
about 2.5 meters, and mark
straight lines at the rear of the
vehicle.
Rear of vehicle
3
Mark four locations on the left
and right 50 cm and 2 m away
from the marks you made in step
2.
2 m
50 cm
MEMO:
• We recommend making an X mark
using packaging or similar tape that
is easily visible from the driver's
seat.
4
Display the guidelines P.37

5
Guideline Adjust
6
Select the four guideline points
you want to adjust.
7
, , ,
Align the marks you made in step 3.
MEMO:
• Continuously holding
down , , , allows you to
move all the guide points together.
8
Repeat steps 6 and 7 to align all
guide points with the marks you
made in step 3.
9
Back
This saves the settings and displays
the regular image in the rear camera.
NX505E 37