Writing Parameter Areas; List Of Parameter Area Writing Commands - Omron ZFV-C Command Reference Manual

Section 2

Writing Parameter Areas

Writing Parameter Areas

The following describes writing of parameter areas.

List of Parameter Area Writing Commands

Data name MRC SRC
Bank
switching
Writing
processing
unit data
*1 This refers to the ASCII character length. For details, refer to p.2-2.
For details on the unit No. and parameter No. of each processing unit, refer to "Section 3
- Unit Nos. and Parameter Nos."
Example 1: To switch the bank of a 2CH controller to "2", assign a command as follows:
MRC
02h
Example 2: To set the threshold value of a 1CH controller (ITEM=match), assign a command as follows:
MRC
02h
ZFV-C
2-6
CompoWay/F Communication Command Reference
Parameter
type
02h 02h 8000h
02h 02h C000h+
<Parameter
No.>
[Machine No.]=0002h, [Data to be written]=0002h
SRC Parameter type
02h 8000h
[Data No.]=28h, [Unit No.]=02h, [Machine No.]=01h, [Data to be written]=00000050h
SRC Parameter type
02h C028h
Specification
Write start
of number of
address
elements
<Machine No.> 8001h
XXYYh 8000h +
(XX: <unit No.>, <Number of
YY: <machine elements>
No.>)
Read start address
0002h
Read start address
0201h
Data to be written length
bank No. (1 to 8) 16
Data to be written 32
Number of Data to be
elements written
8001h 0002h
Number of Data to be
elements written
8001h 00000050h
Data
*1