Channel Setting; Auto Channel Scan - Philips DVDR3505/37 User Manual

If you have changed antenna connection, we recommend that you program available channels in your area with the
following procedures.

Auto Channel Scan

Note
• If the auto channel preset is canceled during
presetting, some channels not yet preset may not be
received.
24 24 EN EN
E7C40UD.indd 24 E7C40UD.indd 24

CHANNEL SETTING

1
Press [SETUP].
2
Use [K / L] to select "Channel", then
press [OK].
"Channel" menu will appear.
3
Use [K / L] to select "Auto Channel
Preset", then press [OK].
4
Use [K / L] to select the type of
broadcasting signal, then press [OK].
Auto Channel Preset
Antenna
Cable (Analog)
Cable (Analog / Digital)
The unit will start getting channels available in
your area.
• When aerial antenna is connected, select
"Antenna".
• When connected to CATV, select "Cable
(Analog)" or "Cable (Analog/Digital)".
To cancel the auto channel preset during
scanning:
Press [BACK ] or [SETUP] to cancel.
5
When scanning is over, press [SETUP]
to exit.
To cycle through only the memorized channels, use
[CH / ].
To select a channel directly (including the ones not
memorized), use [the Number buttons].
2007/01/15 11:19:38 2007/01/15 11:19:38