Table of Contents
Advertisement
If you have changed antenna connection, we recommend that you program available channels in your area with the
following procedures.
Auto Channel Scan
HDD & DVD RECORDER
Note
• If the auto channel preset is canceled during
presetting, some channels not yet preset may not be
received.
E2H42UD_DVDR3576H-37_EN.indd 27
E2H42UD_DVDR3576H-37_EN.indd 27
CHANNEL SETTING
1
Press [SETUP] and use [K / L] to
select "General Setting", then press
[OK].
"General Setting" menu will appear.
2
Use [K / L] to select "Channel", then
press [OK].
"Channel" menu will appear.
3
Use [K / L] to select "Auto Channel
Preset", then press [OK].
4
Use [K / L] to select the type of
broadcasting signal, then press [OK].
Auto Channel Preset
Antenna
Cable (Analog)
Cable (Analog / Digital)
The unit will start getting channels available in
your area.
• When aerial antenna is connected, select
"Antenna".
• When connected to CATV, select "Cable
(Analog)" or "Cable (Analog/Digital)".
To cancel the auto channel preset during
scanning:
Press [BACK
] or [SETUP] to cancel.
5
When scanning is over, press [SETUP]
to exit.
To cycle through only the memorized channels, use
[CH
/
].
To select a channel directly (including the ones not
memorized), use [the Number buttons].
EN
EN
27
27
2007/12/28 11:14:56
2007/12/28 11:14:56
Advertisement
Table of Contents
