Lexus GS430 User Manual page 436

STARTING AND DRIVING
CAUTION
D Deceleration
cruising
warning do not operate when the vehicle ahead is at
a stop or driving very slowly.
D While vehicle−to−vehicle distance control is on (on
follow−up cruising), acceleration and deceleration
are automatically performed in proportion to the
speed of the vehicle ahead detected. However, if the
vehicle ahead of you decelerates abruptly or if
another vehicle cuts in ahead of you, your vehicle
may collide with the vehicle ahead unless you
manually depress the brake pedal to slow down your
vehicle. If you need to accelerate because the vehicle
ahead or you changes lanes, then depress the
acceleration pedal.
D Depending on the road configuration (curved roads,
left and right continuous curved roads, driving at the
start or end of the curve, narrow driving lanes due to
road construction) or your vehicle condition
(steering wheel maneuvering, position in the lane or
unstable driving because of an accident or
breakdown), vehicles in other lanes or surrounding
objects will be detected, resulting in a control failure
or the activated approach warning. This may also
result in a very close distance between vehicles due
to a failure to detect the vehicle ahead. Maneuvering
the steering wheel in response to a violent lateral
wind will cause similar conditions.
412
function and approach
(d) Changing vehicle−to−vehicle distance
G31016
" 1 Long
2 Middle 3 Short
You can select one of the following vehicle−to−vehicle
distances: "Long", "Middle" or "Short". Each time you
pull the distance switch briefly toward you, the setting
changes from "Long" to "Middle" to "Short" and then
back to "Long". You can confirm the setting on the
multi−information display.
It should be noted that pushing the "DISP" switch will change
to another screen.
Your vehicle speed changes in proportion to the speed of
the vehicle ahead, maintaining the selected distance.
However, if the vehicle speed is slower, the selected
distance will be shorter than the designated distance.
When the vehicle−to−vehicle distance control mode is
activated or the multi−information display indicates "RADAR
READY", the vehicle−to−vehicle distance setting can be
changed.