Assembly - Weslo Pursuit 530 User Manual

ASSEMBLY

To hire an authorized service technician to assemble the exercise cycle, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver
adjustable wrench
As you assemble the exercise cycle, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the key number is the quantity needed for assembly. Note: Some small parts may have been pre-
assembled. If a part is not in the hardware kit, check to see if it has been preassembled.
M6 Locknut
(63)–4
M10 Locknut
(33)–4
M6 x 30mm Bolt
(62)–4
.
M8 Locknut
(10)–2
M4 x 5mm
M4 x 8mm
Screw (65)–2
Screw (64)–2
M6 x 30mm Patch
Screw (60)–8
M8 x 115mm Bolt (57)–2
M10 x 65mm Carriage Bolt (30)–4
M6 Washer M8 Split
(61)–8 Washer (42)–4
M4 x 12mm
Screw (25)–1
5
and an
M8 Washer
(14)–4
M4 x 16mm
Screw (49)–4
M8 x 15mm Patch
Screw (34)–4