Weslo Pursuit 530 User Manual page 9

10. While another person holds the Handlebar (15)
near the Upright (13), connect the console wire
to the Extension Wire (36).
Tip: Avoid pinching the wires. Attach the
Handlebar (15) to the Upright (13) with two M8
x 15mm Patch Screws (34) and two M8 Split
Washers (42).
11. While another person holds the Upright (13)
near the Frame (1), connect the Extension Wire
(36) to the Reed Switch Wire (43).
Next, connect the Resistance Cable (19) to the
Lower Cable (45) in the following way:
• See drawing A. Pull up on the metal bracket
on the Lower Cable (45), and insert the tip of
the Resistance Cable (19) into the wire clip
inside the metal bracket as shown.
• See drawing B. Firmly pull up the Resistance
Cable (19) and slide it into the top of the metal
bracket as shown.
• See drawing C. Using pliers, squeeze the
prongs on the upper end of the metal bracket
together.
Insert the excess wire and cable downward into
the Frame (1). Slide the Upright (13) onto the
Frame.
Tip: Avoid pinching the wires and cables.
Attach the Upright (13) with two M8 x 15mm
Patch Screws (34) and two M8 Split Washers
(42).
10
Console
Wire
36
34
42
11
34
42
36
43
1
A B
Metal
Bracket
19
45
9
15
13
Avoid pinching
the wires
13
42
19
45
Avoid pinching the
wires and cables
C
Metal
19
Bracket
45