Weslo Pursuit 530 User Manual page 11

FEATURES OF THE CONSOLE
The console features the following modes that provide
exercise feedback:
• Speed—This mode displays your pedaling speed, in
miles per hour or kilometers per hour.
• Time—This mode displays the elapsed time. Note: If
you stop pedaling, the time mode will pause.
• Distance—This mode displays the distance you
have pedaled, in miles or kilometers.
• Calories—This mode displays the approximate
number of calories you have burned.
• Fat Calories—This mode displays the approximate
number of fat calories you have burned (see Burning
Fat on page 13).
• Pulse—This mode displays your heart rate when
you use the pulse sensor.
• Scan—This mode displays the speed, time, dis-
tance, calories, fat calories, and pulse modes, for a
few seconds each, in a repeating cycle. Note: The
pulse mode will be displayed only while the pulse
sensor is being used.
• Pace—The pace bar on the left side of the display
shows your pedaling pace, in revolutions per minute
(RPM). Note: The pace mode will always be dis-
played while you are pedaling.
HOW TO OPERATE THE CONSOLE
Note: Make sure that there are batteries in the console
(see BATTERY REPLACEMENT on page 12). If there
is a sheet of clear plastic on the console, remove it.
1. Turn on the console.
To turn on the console, press the ON/RESET but-
ton or begin pedaling. All numbers in the display
will appear briefly; the console will then be ready
for use.
2. Select one of the modes:
Scan mode—
When the power
is turned on, the
scan mode will be
selected automati-
cally. One mode
indicator will
appear below the
word SCAN, and
a second mode indicator will show which mode is
currently displayed. Note: If you have selected a
different mode, press the MODE button repeatedly
to reselect the scan mode.
Speed, time, dis-
tance, calories,
or fat calories
mode—To select
one of these
modes for contin-
uous display,
press the MODE
button repeatedly.
The mode indicators will show which mode is
selected. Make sure that there is not a mode indi-
cator below the word SCAN.
To reset the display, press the ON/RESET button.
Note: The console can display speed and dis-
tance in either miles or kilometers. To change
the unit of measurement, press the ON/RESET
button for about five seconds. The letters mph
or km/h will appear in the display to show which
unit of measurement is selected. When the batter-
ies are replaced, it may be necessary to reselect
the desired unit of measurement.
11
Mode Indicators
Mode Indicator