ABB SM3000 User Manual page 94

...4 CONFIGURATION
...4.6.5 Totalizer Configuration
92
Set the value the totalizer counts from and the value applied
when the totalizer is reset.
Set the value at which the totalizer stops or wraps.
Note. A counter configured to count up must have a 'Preset
count' value lower than the 'Predetermined count' value. A
counter configured to count down must have a 'Preset
count' value greater than the 'Predetermined count' value.
Set the required number of decimal places on the higher of
the 'Preset count' value or 'Predetermined count' value.
Set the value at which a digital source is activated. This can be
used as an alarm threshold to indicate when the
'Predetermined count' value is about to be reached.
Select a signal source to reset the totalizer on a rising edge.
Refer to APPENDIX 1 for a description of the available
sources.
Select the frequency with which totalizer values are added to
the Totalizer log.
L o g u p d a e t i t m e
5 m n i t u s e , 0 , 5 1 , 0 1
1 0 m n i t u s e , 0 1 , 0 2 , 0
1 5 m n i t u s e , 0 1 , 5 3 , 0
2 0 m n i t u s e , 0 2 , 0 4 0
3 0 m n i t u s e , 0 3 0 m n i t u
6 0 m n i t u s e O n h t e h o
2 h o u s r M d i n g i h , t
3 h o u s r M d i n g i h , t
4 h o u s r M d i n g i h , t
8 h o u s r M d i n g i h , t
1 2 h o u s r M d i n g i h , t
2 4 h o u s r M d i n g i t h
Select a signal source to trigger the addition of the current
totalizer values to the Totalizer log on a rising edge. Refer to
APPENDIX 1 for a description of the available sources.
L o g u p d a e t d e v e y r . . .
5 . . . t e . c m n i t u s e p a t s h t e h o r u
3 , 0 . . . t e . c m n i t u s e p a t s h t e h o
4 5 m n i t u s e p a t s h t e h o r u
m n i t u s e p a t s h t e h o r u
s e p a t s h t e h o r u
r u
2 a m , 4 a m , t e . c
3 a m , 6 a m , t e . c
4 a m , 8 a m , t e . c
8 a m , 4 p m , t e . c
1 2 a m
r u