ABB SM3000 User Manual page 62

...4 CONFIGURATION
...4.4.1 Setup
60
Set the current date and time.
Note. If daylight saving is required, enter the settings (see
next page) setting the time and date as the operation
before
of the internal clock is affected by the daylight saving
settings.
Notes.
• The date and time cannot be adjusted if recording is
enabled during configuration, i.e the 'Disable recording in
configuration' check box is
Configuration level – see Fig. 4.1, page 49.
• Changes to the date and time are effective immediately
upon selecting 'OK' in the dialog box above. Selecting
'Cancel' upon exiting Configuration Mode (see Fig. 4.7,
page 57) reset the clock to its previous setting.
does not
Select 'Cancel' in the dialog box above to exit date and
time setup without saving changes.
• Setting an earlier date or time results in the loss of all data
currently in the internal buffer memory past that date. Data
archived to external media is unaffected. If an earlier time
must be set, change the Instrument Tag (see below). This
causes new archive files to be created and the duplicated
hour of data is then saved to the new files.
• Time changes due to automatic daylight saving do not
affect the recorded data.
• Archive files created during the daylight saving period (see
Section 4.5.6) are compatible with the database feature of
Version 5.8 (or later) only of the Company's DataManager
data analysis software package.
ticked on entry to the
not