Fireplace Installation - Dimplex DF2608 Owner's Manual

Fireplace Installation

WARNING: Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk
of ire, electric shock or injury to
persons.
WARNING: Construction
and electrical outlet wiring must
comply with local building codes
and other applicable regulations
to reduce the risk of ire, electric
shock and injury to persons.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of ire,
electric shock or injury to persons,
always use a licensed electrician.
WARNING: To reduce the risk
of ire, do not store or use gaso-
line or other lammable vapors or
Figure 1
22 ⅞"
(580
mm)
27 ⅜"
(695 mm)
liquids in the vicinity of the heater.
CAUTION:
circulation beneath the ire-
place insert is provided by two
rubber feet.
Do not install the ireplace
insert directly on carpet or
similar surfaces which may
restrict air circulation.
CAUTION:
ireplace in a carpeted area, place
a one-piece, solid, lat surface
under the ireplace. Ensure that
both of the feet rest securely on
this surface.
! NOTE: The dimensions of the
ireplace with the trim are
27 ⅜ in. (695 mm) wide x 23
½ in. (596 mm) high x 8 3/4 in.
(222 mm) deep. Dimensions
without trim are 26 ¼ in. (663
mm) wide x 22 ⅞ in. (580 mm)
23 ½"
(596 mm)
Clearance for air
If installing the
26 ¼"
(663 mm)
8 ¾"
(222 mm)
7