Dimplex DF2608 Owner's Manual page 12

Operation
sired temperature, turn the ther-
mostat knob counter clockwise
until you hear a click. Leave in
this position to maintain the room
temperature at its setting. For
additional heat, turn clockwise
until you hear the click again and
the heater will turn on. To turn the
heater off, rotate the knob fully
counter clockwise.
Resetting the Temperature
Cutoff Switch
This unit is equipped with a ther-
mostat which controls the tem-
perature of the room by turning
the heater on and off. The heater
is protected with a safety device
to prevent overheating. Should
the heater overheat, an automatic
cut out will turn the heater off and
it will not come back on without
being reset. It can be reset by
switching the 3-Position Switch
to Off and waiting ive minutes
before switching the unit back on.
CAUTION: If you need to con-
tinuously reset the heater, un-
plug the unit and call Technical
Support at 1-888-346-7539.
Please have your model and
serial number ready when call-
ing.
12
Remote Control
The ireplace is supplied with an
integrated on/off remote control.
! NOTE: Ensure that the
3-Position Switch on the
ireplace is set to the remote
control setting (" II "posi-
tion).
To operate, push the ON button
to turn the ireplace on, push the
OFF button to turn the ireplace
off.
!
NOTE: Before attempting any
operation with the remote, pull
the plastic insulator strip out
from between the remote cas-
ing and battery cover (Figure
6).
Figure 6
On
Button
Off
Button
Plastic
strip
Battery
cover
(Figure 6)
www.dimplex.com