Dimplex DF2608 Owner's Manual page 13

Operation
Remote Control Initialization/
Reprogramming
Follow these steps for remote
control initialization and if re-
quired, re-initialization:
1. Disconnect power to ire-
place.
2. Set the 3-Position Switch to
the Remote position (Figure
5A).
3. Wait a minimum of ive
seconds and then re-acquire
power to ireplace.
4. Within 10 seconds of re-ac-
quiring power, press the ON
button located on the remote
control.
!
NOTE: You will have only 10
seconds to perform this last
step. Failure to do so will
result in these steps needing
to be followed again.
This will synchronize the remote
control and receiver.
Battery Replacement (Figure 6)
To replace the battery:
• Slide battery cover open on
the remote control.
• Correctly install one 12 Volt
(A23) battery in the battery
holder.
• Close the battery cover.
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or Retailer for recycling
advice in your area.
13