NETGEAR ProSAFE WC7500 User Manual page 162

12. Click the Add button.
Depending on the type of access points that were discovered, a page that lets you enter
or ignore a login name and a password might display.
13. If necessary, enter the login name and password.
The Managed AP List page displays. Because this page is wide, it is shown in the
following two figures.
After the access points are added to the Managed AP List, the wireless controller
upgrades the firmware of the access points to the latest firmware that is loaded on the
wireless controller, and the access points become managed access points. Depending
on the number of access points that you add to the Managed AP List, this process might
take several minutes.
By default, the access point upgrade process uses multicast. If you must configure a
specific multicast IP address range for the upgrade process or disable multicast, see
Configure Multicast Firmware Upgrade for Access Points
ProSAFE Wireless Controller
Discover and Manage Access Points
162
on page 278.