Tail Lights; License Plate Lights - Porsche 928 1982 Owner's Manual

Fog lights
1 - remove screws from plastic trim, takeoff
trim
2 - remove Philips screws. Take off lamp
3 - disconnect wire. Push down holding
clamp for bulb
4 - remove defective bulb and replace. Be
sure guide pins on bulb base fit into
socket of reflector
5 - reinstall lamp, tighten screws. Check
functioning and adjustment of light
6 - install plastic trim and tighten retaining
screws.

Tail lights

The tail lights are housed in one unit.
A - turn signal light
Β - tail light
1 - Remove Philips screws and lamp lens.
2- Replace bulb.
3- Reinstall lamp lens and tighten Philips
screws evenly, alternating from one to
the other.
4 - Check light.

License plate lights

C - stop light
1 - Unscrew both screws and lift out lamp
D - back-up light
housing.
2- Replace bulb.
3- Reinstall lamp housing and make sure
it is firmly seated.
4 - C h e c k light.
77