Porsche 928 1982 Owner's Manual page 73

Lifting car with car jack
The car should be jacked up only at the
jackport points illustrated above and on pre-
ceding page (black arrows).
Caution: If work is to be done underneath
the vehicle, the car must be supported
by suitable chassis stands or raised with
a workshop hoist.
Lifting car with workshop hoist
Make sure there is sufficient clearance be-
tween pads and vehicle, before driving car
on hoist. The car must only be lifted at the
lift pad points illustrated on preceding page
(white arrows).
The rear lifting points are located on the rear
axle control arm mount illustrated above
(arrow).
Lifting car with floor jack
The same lifting points illustrated for the
hoist also apply when using a floor jack. The
rear end of the car can also be lifted with a
floor jack in the center of the rear suspension
cross member. To avoid possible damage,
it is recommended to insert a wooden disc
or a rubber pad between the floor jack and
the lift point pads as illustrated above.
Caution: The vehicle should never be
jacked up from underneath the engine oil
pan or the transmission. Severe damage
could result.
71