Table of Contents
Advertisement
Operating Controls
7
Plus/minus keys
.05.02
The selection and changing of setting values (e.g. entering the backtack stitches) can be
carried out using the corresponding +/- keys. At the same time the set value shown above is
changed slowly at first by pressing and holding the corresponding plus or minus key. If the
key is held pressed for longer, the set value changes more quickly.
7
Plus/minus keys
.05.03
If a function is on, this is always indicated by the correspondingly lit LED.
Detailed explanation of functions:
Start backtack
O The seam lock at seam start (start backtack) is turned on or off by pressing this key.
End backtack
O The seam lock at seam end (end backtack) is turned on or off by pressing this key. The
Edge trimming
O The "Edge trimming" function is switched on or off by pressing this key.
Template drive
O The "Template drive" function is switched on or off by pressing this key.
Foot position after thread trimming
O The "Foot position up after thread trimming" function is turned on or off by pressing this
Thread trimming
O The "Thread trimming" function is switched on and off using this key.
18
Fig. 7 - 06
The number of forward stitches (A) or reverse stitches (B) of the start backtack can be
changed respectively by pressing the +/- key underneath. To convert from double back-
tack to single backtack, reset the number of stitches (A).
number of reverse stitches (C) or forward stitches (D) can be changed respectively by
pressing the +/- key underneath. To convert from double backtack to single backtack,
reset the number of forward stitches (D).
key. If this function is on, the sewing foot is raised after the thread has been trimmed.
A B C D
3 3 3 3
Advertisement
Table of Contents
