Installation Instructions - Cadet COM-PAK Owner's Manual

Cst electric wall heater
Hide thumbs Also See for COM-PAK:
Table of Contents

Advertisement

INSTALLATION INSTRUCTIONS

1. All electrical work and materials
must comply with the National
Electric Code (NEC), the Occu-
pational Safety and Health Act
(OSHA), and all state and local
codes.
2. Use copper conductors only.
3. DO
NOT
directly above bathtub or sink.
DO NOT install in shower stall
area. Manufacturer recommends
a minimum 2 foot (61 cm) side
clearance.
4. Heater must be installed in a wall
can:
Model CS - wall can models CC
or CCSM
Model CST - wall can model CTC
If you are uncomfortable working with electricity, running electrical supply
wire or installing a circuit breaker, please consult a licensed electrician.
• Make sure the heater is the same voltage as the electrical supply wires you're
using. The wire size must be correct for the voltage, the heater wattage and
the circuit breaker.
• CHECK YOUR BREAKER! If you're replacing an existing heater, check the
labels of the old heater and use the same voltage.
single-pole breaker
• Connecting a 120 volt heater to a 240 volt electrical supply will destroy the
heater and void your warranty! Connecting a 240 volt heater to a 120 volt
electrical supply will only give you one quarter of the heat output.
Unanswered questions? Call our technical support team in Vancouver,
Washington at 855.CADET.US.
high-temperature
safety shutoffs
built-in thermostat
(optional)
install
the
heater
KNOW YOUR VOLTAGE!
PARTS OF YOUR HEATER
rating label
3
5. DO NOT install the heater in a floor,
below a towel bar, behind a door,
or anywhere the air discharge may
be blocked in any manner.
6. A heater has hot and arcing or
sparking parts inside. Do not use
it in areas where gasoline, paint,
or flammable vapors or liquids are
used or stored.
7. Connect grounding lead to ground-
ing screw provided. Keep all for-
eign objects out of heater.
8. CAUTION-High temperature, risk
of fire, keep electrical cords, drap-
ery, furnishings, and other com-
bustibles at least 3 feet (0.9 m)
from the front of the heater and
away from the side.
double-pole breaker
heater element
fan and
motor

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Com-pak twin

Table of Contents