Cadet Softheat EBHN500 Owner's Manual

OWNER'S GUIDE
Features & Benefits
Whisper quiet operation and low surface temperatures
•
Filled with non-toxic, non-hazardous thermal fluid
•
Self-contained hermetically sealed element design requires no
•
plumbing, piping, or other water supply
Thermal fluid capacity offers better heat retention, which creates
•
less cycling and keeps more consistent room temperatures
Designed to reduce the effects of indoor allergens
•
7-year element warranty
•
IMPORTANT INSTRUCTIONS
WARNING!
Turn the electrical power off at the electrical panel
board (circuit breaker or fuse box) and lock or tag the
panel board door to prevent someone from turning
on power while you are working on the heater.
Failure to do so could result in serious electrical
shock, burns, or possible death.
When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock, and
injury to persons, including the following:
1. Read all instructions and labels before installing this heater.
2. WARNING
A heater has hot and arcing parts inside. Do not install in
areas where gasoline, paint or flammable liquids are stored or
excessive lint or dust are present.
3. WARNING
This heater is hot when in use. To avoid burns, do not let bare skin
touch hot surfaces. Keep combustible materials, such as furniture,
pillows, bedding, papers, clothes and curtains away from heater.
4. To prevent possible fire, do not block air intakes or exhaust in
any manner. Do not use on soft surfaces, like a bed, where
openings may become blocked. Heaters must be kept clean of
excessive lint, dirt and debris. (See Maintenance Instructions).
SAVE THESE INSTRUCTIONS
Tel: 360-693-2505 www.cadetco.com P.O. Box 1675 Vancouver, WA 98668-1675
5. Risk of electrical shock. Do not insert or allow foreign objects to
enter any ventilation or exhaust opening as this may cause an
electric shock or fire, or damage the heater.
6. Do not place heater below an electrical convenience receptacle.
7. WARNING
Overheating or fire may occur. Do not install the heater behind
doors.
8. Use extreme caution when any heater is used near children or
invalids and whenever the heater is left operating unattended.
9. WARNING
Do not operate after heater malfunctions or has been dropped
or damaged in any manner.
10. WARNING
Risk of fire. Do not block heater minimum of 12 inches in front
and above, 6 inches on both sides.
11.Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause fire, electrical
shock, or injury to persons.
12.Verify that the electrical supply wires are the same voltage as
the heater. The heater must be grounded to the grounding
screw provided. If you need to install a new circuit or need
additional wiring information, consult a qualified electrician.
MODELS:
EBHN500
EBHN750
EBHN1000
EBHN1250
EBHN1500
EBHN500-8
EBHN750-8
EBHN1000-8
EBHN1250-8
EBHN1500-8
TOOLS REQUIRED
Phillips Screwdriver
•
Straight Screwdriver
•
Wire Strippers
•
Drill or Hammer
•
Level
•
Punch or Chisel
•
Drill Bits
•
Utility Knife
•
(4) Wood Screws
•
(3) Wire Nuts
•
(1) Strain Relief Connector
•