Intended Use - DeWalt DWH052 Instruction Manual

INTENDED USE

Your demolition dust extraction system has been designed for
professional demolition and breaking applications in concrete and
masonry. Using the appropriate breaker, chisel and dust extractor
vacuum it can be used to remove the vast majority of static and
airborne dust which without the use of the dust extraction system
could otherwise contaminate the working environment or pose an
increased health risk to the operator and those in close proximity.
Recommended power tools to be used with this attachment
are available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any power tool,
please contact D WALT Industrial Tool Co., 701 East Joppa Road,
E
Baltimore, MD 21286, call 1-800-4-D
visit our website www.dewalt.com.
DO NOT use under wet conditions or in presence of flammable
liquids or gases.
The demolition dust extraction system is a professional tool.
DO NOT let children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.
ASSEMBLY
WARNING: ALWAYS turn off tool and disconnect the tool
from the power source before making any adjustments or
removing or installing attachments or accessories. This applies
to both the demolition tool and the dust extractor vacuum.
Such preventative safety measures reduce the risk of starting the
tool accidentally.
CAUTION: Use only pointed and flat chisels with the demolition
dust extraction system.
Attach Dust Extraction System to Tool
(Fig. 1–5)
WALT (1-800-433-9258) or
E
FIG. 3
4
1. Insert chisel (F) as instructed in the tool instruction manual.
NOTE: Maximum chisel width is 1.25" (32 mm).
2. Slide the nozzle (A) over the chisel. Ensure the narrow end of the
nozzle is first.
FIG. 2
F
3. Attach the adjustable strap (D) to the bracket (C) as shown.
IMPORTANT: Observe the difference between the hooks (G, H)
on bracket (C). Adjustable strap MUST be attached to hook (H)
as shown.
C
H
G
A
D
H