AEG Favorit CE Instruction Book page 48

26. Description of the options
Option .... half load
- Chooseable to all programs, except „Prewash“
- If the choosen program has a phase „prewash“, this phase is skipped.
- The speed of the circulation pump is reduced in the filling step.
- Reduction of average time are 28 minutes by intensiv programmes, 18 minutes by
programmes. The water consumption is reduced about 5 liters.
Option .... rinse +
- Chooseable to all programs, except
„Prewash“, „Quick“-, „Glass“-program and „Energysaving“
- An additional prewash phase is added to the program cycle.
Option .... superwash
- Chooseable to all programs, except
„Prewash“, „Quick“-, „Glass“-program and „Energysaving“
- Changes in the prewash phase (not available in Eco 65° and Eco Bio 50°)
o hot prewash with higher temperature. Temperature is increased from 40°C to 55°C.
o Two soaking phases of 5 minutes duration are added to the cycle.
Inbetween these phases the circulation pump is activated for a short time.
In this soaking phases, the soil is softened and comes off.
o Additional prewash time of total 7 minutes is added. During this time the temperature is
kept on 55°C by enableing re-heating.
o The duration of the program phase „prewash“ is increased with this option by 18-20
minutes
- Changes in the cleaning phase.
o Additional 6 minutes of cleaning, with heating to max. 55°C
o Additional 20 minutes cleaning with a controlled temperature of 70°C (resp. 65°).
o The duration of the program phase „cleaning“ is increased with this option by approx.
26 minutes.
- This option doesn’t influence the program cycle in the phases „hot rinse“ and „drying“. In the
program „Normal 65°C“ an additional 2nd intermediate rinse is run, as already available in
the Intensive program.
Option .... reduce / increase temperature
- Chooseable to all programs, except
„Prewash“, „Quick“-, „Glass“-program and „Energysaving
- Important!
Per device, it is only possible either to increase or to decrease the temperature by an option
button. This has to be carefully watched when building variants!
- This option exclusively influences the temperatures in Prewash and Cleaning.
The temperature in Hot Rinse remains unchanged.
- The value for temperature in- or decrease is stored in EEProm and therefore changeable for
different variants.
Option .... tablet program
- Chooseable to all programs, except
„Prewash“, „Quick“- and „Glass“-program
- To better dissolve the tabs, and additional temperature step of 40°C is added in the cleaning
phase.
- Due to this, the time of this phase is increased by approx. 5 minutes.
Spares Operation - R.Kurzke 02/02
- 20 -
599 513 616 EN