Information For Test Centres - AEG Favorit CE Instruction Book

Electrical connection
The dishwasher is supplied with a lead and electrical plug for connection
to a 230 V earthed wall socket, which should be easily accessible and
protected by a 10 A fuse.
Permanent electrical installation must be carried out by an authorized
electrician or competent person.
Before any work is carried out on the dishwasher, it must be isolated
from the electric mains supply, for example by removing the plug
from the wall socket.

Information for test centres

The salt container and rinse aid dispenser shall be filled in accordance
with this instruction manual.
Before conducting the measurements the dishwasher shall be operated
for one or two complete cycles using detergent and a clean load.
Test standard:
Rated capacity:
Loading of basket:
Test program:
Detergent (IEC Type B):
Rinse aid (Type III):
Water pressure:
Waste water outlet:
Position- and connection instructions
EN 50242 and EN 60704
6 place settings accordance EN 50242
see chapter "Loading the dishes"
Eco 55° C
15 gram in the dispenser + 3 gram in the
pre-wash dispenser
setting 3
minimum 0,8 bar, maximum 10 bar
install according to figure below
27