Electrical; Final Check List - Scotsman CU1526MA-6 Installation Manual

Electrical

The machine is supplied with a power cord, and
only requires the addition of a plug. Connect the
plug to the power cord in compliance with the local
electrical codes. Select an appropriately certified
plug based on the country of use, current rating of
the appliance and suitability for use with 1.5 mm2 x
3 conductor type H05VV-F cord.
This is a cord-connected unit, and must be
connected to a separate power supply. Check the
dataplate for the voltage, ampacity and maximum
fuse size and per the dataplate use fuses or HACR
circuit breakers.
Note: In case the power cord is damaged, it
must be replaced by a like cord. Replacement
cords are available from Scotsman's local
representative. Replacement should only be
done by a qualified technician to prevent
possible risks.
Follow All Local Codes - This Unit Must Be
Grounded. Do not use extension cords and do not
disable or by-pass ground prong on electrical plug.
The power cord plug will be the disconnect means
for this machine.

Final Check List

After connections,
1. Wash out the bin. If desired, the interior of the
bin could be sanitized.
2. Locate the ice scoop (if supplied) and have it
available for use when needed.
Final Check List:
1. Is the unit located indoors in a controlled
environment?
2. Is the unit located where it can receive
adequate cooling air?
3. Has the correct electrical power been supplied
to the machine?
4. Have all the water supply connections been
made?
5. Have all the drain connections been made?
6. Has the unit been leveled?
7. Have all unpacking materials and tape been
removed?
8. Is the water pressure adequate?
9. Have the drain connections been checked for
leaks?
10. Has the bin interior been wiped clean or
sanitized?
11. Have any water filter cartridges been replaced?
12. Have all required kits and adapters been
properly installed?
2007
Page 7
CU1526, CU2026, CU3030
Installation Manual