Using The Sandblasting Gun - Parkside PDSP 1000 A1 Operation And Safety Notes

operation
E nsure that the blast medium is completely dry and not too coarse.
NOTE: The maximum particle size is 0.8 mm.
T urn the bayonet cap of the blast medium container
P ull the blast medium container
F ill the blast medium container
blast medium.
E nsure that the maximum capacity of the container (1000 ml) is
not exceeded.
S crew the blast medium container
by inserting and turning it on to the container lid (see Figs. A).

Using the sandblasting gun

Q
(see Figs. b, c)
C arefully prepare the workpiece before sand blasting it.
Clean it if necessary.
NOTE: Deposits of dust and grease can have a considerably
detrimental effect on the result.
C arefully mask or tape off everything that is not to be sand blasted.
E nsure that there is always a minimum distance of 20 cm between
the sandblasting gun
Switching on:
P ress the trigger
Switching off:
r elease the trigger
A fter you finish work, disconnect the device from the compressed
air source.
NOTE: First disconnect the hose from the compressed
air source and only then disconnect the compressed
44 GB/MT
4
4
and the surface being sand blasted.
1
to start operating the sandblasting gun
2
to stop operating the sandblasting gun
2
off downwards.
with the desired amount of
back on and lock it in place
4
to open it.
4
.
1
.
1