Honeywell FocusPRO TH6110D Installation Manual page 2

Installation Guide
1. Separate wallplate from thermostat.
2. Mount waltplate as shown below.
It's easier to grasp the wallplate
and remove it after completely
removing the battery holder.
Remove battery holder.
Pull here to remove wallplate
from new thermostat.
tnsert reference card after wallplate is
mounted (see instructions, below).
Drill 3/16" holes for drywall. Drill 7/32" holes for plaster.
CAUTION: ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect power before
beginning installation.
MERCURY NOTICE
If this product is replacing a control that contains mercury in a sealed tube, do not
place the old control in the trash. Contact your local waste management authority for
instructions regarding recycling and proper disposal.