Bottom Plate - Brother MFC7050C Service Manual

1.19 Bottom Plate

(1) Remove two "x" screws and six "y" screws.
(2) Lightly lift up the rear edge of the bottom plate and disconnect the centro harnesses (1 and 2)
and power supply harnesses (1 and 2).
(3) If the upper cover ASSY has not been removed so that the grounding wire has not been
released from the frame chassis, you need to release the grounding wire from the bottom
plate by removing screw "z" (see the illustration given on the next page).
(4) Pull out the AC cord bushing from the lower cover, then remove the bottom plate (together
with the interface PCB and power supply PCB).
IV - 38