Advertisement
Remote Start Operation and Feature Programming (Stage 2)
Stage 2: Remote Start Operation Programming
In this mode you will program the type of engine starting detection you want to use in your installation. There are
3 types available:
1. Tachometer (RPM) Detection: (Most reliable and recommended) This type of detection requires
a hard wire connection to the vehicles ignition coil.
2. Voltage Detection: This method detects the drop and rise in the battery voltage when the vehicle is started
by remote. This type of detection requires a solid main power input connection but it does not require any
additional hard wire connections.
3. Elapsed Timer: This method is the easiest for installation but is not always the best method for year round
usage (Summer and winter). To operate this method, you will program a specific time window for the remote
start unit to crank the engine. Battery strength, environment and the aging process of the vehicle may require
the timer to reset from time to time or season to season.
Entering Stage 2 Remote Start Operation Programming
OFF
Turn the ignition switch from the OFF position to the
ON position 3 times leaving it in the OFF position
the third time.
Use the transmitter buttons as illustrated to adjust the features required. Keep re-pressing the transmitter button that
relates to the feature you want to adjust until the correct amount of chirp/beeps is heard. Move on to the next feature.
Button
LED One Pulse
(Factory Default Setting)
Exit the Programming Mode (3 long chirps and 3 parking light flashes to confirm this exit)
Tachometer
+
Checking Type
RPM Learning
Start Timer:
0.6 second (1 chirp)
Low Check Level
-
Start or Stop the System for Testing & Adjusting
"TEST" Mode for Zone 2
+
Instant Trigger & Zone 3
Door Trigger
Exit: Press the
button on the transmitter. 3 long chirps and 3 parking light flashes confirms exit.
22
Step 1
Remote Start Feature Programming
One Chirp
Voltage Checking
0.8 second (2 chirps)
1.4 second (5 chirps)
2.0 second (8 chirps)
High Check Level
(2 Stage Shock Sensor)
ON
3X
Before 15 seconds has passed, push and release the valet
switch nine (9) times then push the valet switch a tenth
time and hold it down until five (5) short chirps/beeps +
one (1) long chirp beep is heard then release it. You are
now in stage 2 remote start feature programming mode.
Step 3
Two Chirps
LED Two Pulse
Type
1.0 second (3 chirps)
1.6 second (6 chirps)
3.0 second (9 chirps)
"TEST" Mode for
Zone 1 & Zone 4
Step 2
9X + 1X (Hold)
Three Chirps
LED Three Pulse
Timer
Checking Type
Four Chirps
LED Four Pulse
1.2 second (4 chirps)
1.8 second (7 chirps)
4.0 second (10 chirps)
Advertisement
