Programming: Software Upgrade And Flexing; Part Numbers - Motorola MOTORIZR Z6tv Service Manual

Level 1 and 2 Service Manual
Table 3. Level 1 and 2 Troubleshooting Chart (Continued)
SYMPTOM
6. Receive audio from earpiece speaker is
weak or distorted.
7. Phone does not sense when slider is
opened or closed (usually indicated by
inability to answer incoming calls by
opening the flip, or inability to make
outgoing calls).
8. Internal Charger not working.

Programming: Software Upgrade and Flexing

Part Numbers

6809513A80-B
PROBABLE CAUSE
a) Connections to or from transceiver
board assembly defective.
b) Slider assembly defective.
c) Antenna assembly defective.
d) Transceiver board assembly
defective.
a) Transceiver board assembly
defective.
Faulty charger circuit on transceiver
board assembly.
Contact your local technical support engineer for information about equipment and
procedures for flashing and flexing.
The following information is provided as a reference for the parts associated with
Z6m/Z6tv telephones.
February 19, 2008
VERIFICATION AND REMEDY
Gain access to the transceiver board assembly
as described in the procedures. Check flex and
the flex connector from the slider assembly to
the transceiver board assembly. If flex is at fault,
replace slider assembly. If flex connector is at
fault, proceed to d. If connection is not at fault,
proceed to b.
Temporarily replace the slider assembly with a
known good assembly. If fault has been cleared,
reassemble with the new slider assembly. If fault
not cleared, proceed to c.
Check to make sure the antenna is installed
correctly. If the antenna is installed correctly,
substitute a known good antenna assembly. If
this does not clear the fault, reinstall the original
antenna assembly and proceed to d.
Refer service to authorized Level 3 service
center for replacement.
Refer service to authorized Level 3 service
center for replacement.
Refer service to authorized Level 3 service
center for replacement.
Troubleshooting
75