Level 1 and 2 Service Manual
6809513A80-B
5.
Starting at the top of the phone, slightly separate the front & rear housings.
Gently disengage center 2 snaps (1 on each side).
Housing snap
location
Housing snap
location
Figure 10. Releasing the Housing Snaps
6.
To release the bottom 2 side snaps, start by using a disassembly pick in the
location shown (access hole on either side of phone) to pry the front housing
outward releasing the lower side rear housing loop. Use caution to avoid
damaging the housing with the pry tool. The objective is to deflect the front
housing side wall, not the rear housing loop in order to disengage the snap.
Repeat for both side snaps (see Figure 11 on page 22).
February 19, 2008
Rear housing
Disassembly
v46319
21