Motorola MOTORIZR Z6tv Service Manual page 59

Level 1 and 2 Service Manual
6809513A80-B
4. Grab the keypad flex and connect it to the hydra-flex connector as shown.
Figure 70. Connecting the Keypad Flex
5. Handle the flex very carefully to prevent damage.
6. The display liner must be removed prior to closing the slider outer and inner
housing (Fig.2) use a light blast of ionized air to eliminate any foreign matter
on the display and inside the display lens.
7. After the keypad flex connector is attached to the hydra-flex, relocate the slider
guide to about half way at the slider then ski boot the inner housing into the
slider outer and at the same time, close the angle between the two components.
Make sure that the delrin rails are in the proper position.
8. Hold the slider assembly vertically and carefully slide the slider guide to the
lower position be, extremely careful not to damage the transceiver flex that is
hanging from the rear of the assembly.
February 19, 2008
Disassembly
K flex
v463424
59