Secondary Air Tube Removal / Installation - Regency Kingston F3502B Owners & Installation Manual

maintenance
|
22
BYPASS DOOR BOLT BRACKET ASSEMBLY
REPLACEMENT
If any of the bolts used to secure the bypass door become damaged - the
bypass door bolt bracket assembly can be replaced.
1. Allow the stove to burn out and cool down, until cool to touch.
2. Remove bypass door before attempting to remove bolt bracket assembly—
see detailed instructions on previous page.
3. Open stove door and remove stainless steel smoke deflector, flame shield
and catalytic combustor to access bypass door—see detailed instructions
in this manual.
4. Lift out (front or rear) bypass door bolt bracket assembly and replace with
a new one.
Note: The rear nuts which are only loosened when removing the by pass door
will need to be removed in order to remove the bolt bracket assembly.
Bypass door bolt
bracket removed
5. Reverse steps to reassemble stove.
22 | F3502B Freestanding Woodfire
SECONDARY AIR TUBE REMOVAL /
INSTALLATION
1. Allow the stove to burn out and cool down, until cool to touch.
2. Open stove door to access secondary air tube.
Secondary Air
Tube
Bypass door bolt
bracket
3. Grasp secondary air tube firmly with vise grips, using a hammer tap vise
grips from right to left until air tube is released from grip. Remove.
4. To reinstall or replace, first slide left side of tube into hole on left side air
channel. Align tab on right side air channel with notch on right hand end of
air tube. Firmly grip center of air tube with vise grips, use hammer to tap vise
grips from left to right until the tube bottoms out into the air channel on right.