Table of Contents
Advertisement
3. To remove the wiper blade, press the
plastic adaptor (1) and pull (2) the
wiper blade.
E147762
1.
To assemble the wiper blade, slide (3)
the new blade onto the wiper arm until
you here a snap (4).
2. Lower the wiper arm back to it's
working position.
REMOVING A HEADLAMP
1.
Open the hood. See Opening and
Closing the Hood (page 116).
2
E144433
2. Remove the screws and push pins.
Ecosport (CBY) Rayong (Thailand)/Haiduong (Vietnam), enPHI
Maintenance
2
3
4
3. Lift the outer side of the headlamp to
disengage it from the lower fixing point.
4. Pull the headlamp as far as possible
toward the center of your vehicle and
remove.
E164963
5. Disconnect the two electrical
connectors.
Note: When fitting the headlamp, make
sure that you reconnect the electrical
connector correctly.
Note: When fitting the headlamp, make
sure that you fully engage the headlamp in
the lower fixing point.
CHANGING A BULB
WARNINGS
Switch the lights and the ignition off.
Let the bulb cool down before
removing it.
Do not touch the glass of the new
bulb.
Note: Only fit bulbs of the correct
specification.
Note: The following instructions describe
how to remove the bulbs. Fit replacements
in the reverse order unless otherwise stated.
124
Advertisement
Table of Contents
